TECHNOLOGY SAFETY RULES
Safety has always been an important part of the technology program at Unit 5. The very nature of technology laboratory work with its inherent hazards, machines, tools, and materials, requires that a considerable amount of attention to be devoted to safety instruction.
There shall be absolutely _________________ in or around the lab. This lab is a place for purposeful activities, where the workers must direct their undivided attention to what they are doing.
Always follow the ____________ of the teacher. By doing the job differently, you endanger your safety and the safety of those around you.
Appropriate ______ is necessary. This means _________ rolled up, ____________ removed, and _________ tied back.
Do not ______________ workers while they are running machines or using sharp hand tools.
Operate machines only after being ___________ to do so by the teacher.
The _____________________ around the machines and other working areas should be cleared of all unnecessary materials. The floor should be watched for oil, grease, sawdust, etc.
Before starting a machine make sure that the machine is in condition to __________________. Also, be sure that tools and bits are mounted securely.
Never attempt to make _______________ on a machine while it is plugged in.
Before operating a machine be sure that all the _______________ is in place and operating correctly.
Leaving a machine while it is still running is ____________ so wait until it has stopped before you leave.
Use the _________ tool for the _________ job, and be sure that it is the right ________.
Learn the location of the nearest fire __________ and ____________ in the lab.
_____________________ must be worn at all times when you are working in the lab.
It is the responsibility of each student to report all __________ to themselves or others to the teacher.
Observe all ________________. These rules are for the effective and safe operation of the institution in the best interest of all concerned.
ABOVE ALL ELSE, _______________________________!